6-UNPACKING
6.1 Uncrating
The envelope attached to the shipping box contains
the uncrating instructions of the machine (Figure 6-1).
Cut straps. Cut out staple positions along the
bottom of the shipping box (or remove staples
with an appropriate tool - Figure 6-2)
After cutting out or removing the staples, lift the
shipping box in order to clear the machine
(two persons required).
Transport the machine with a fork-lift truck
to the operating position.
Lift the pallet at the point indicated in Figure 6-3
(weight of machine + pallet = see Section 4).
a20-NA
Figure 6-1
Figure 6-2
Figure 6-3
Removal of Pallet
Using a 10mm combination wrench, remove the
fasteners that secure the case sealer legs to pallet at
each leg (as shown in Figure 6-4).
Fasteners
Figure 6-4
Remove the leg height adjustment cap screws and
replace with the cap screws from the tool kit. Loosen
both cap screws. Remove and replace them one at
a time to keep the inner threaded plate in position.
Using a 3mm hex wrench, remove the Height
Adjustment Handle and reinstall it with the handle
pointing upward as shown in Figure 6-5.
Figure 6-5
6.2 Disposal of Packaging Materials
The a20 package is composed of:
- Wooden pallet
- Cardboard shipping box
- Wooden supports
- Metal fi xing brackets
- PU foam protection
- PP plastic straps
- Dehydrating salts in bag
- Special bag of laminated polyester/aluminium/
Polyethylene (sea freight package only)
- Polyethylene protective material
For the disposal of the above materials, please follow
the environmental directives or the law in your country.
16
2011 April