Cleaning - 3M Matic 8000a-I Instructions And Parts List

Maintenance

Cleaning

Regular slotted containers produce a
great deal of dust and paper chips
when conveyed through taping
heads. If this dust is allowed to
build-up on the heads, it can cause
wear on the moving parts.
Excessive dirt build-up should be
wiped off with a damp cloth.
Cleaning should be done once per
month, depending on the number
and type of boxes used. If the boxes
used are dirty, or if the environment
in which the heads operate is dusty,
cleaning on a more frequent basis
may be necessary.
Note – Never attempt to remove
Applying/Buffing Roller
Replacement
Replacing roller requires removal
of shaft and mounting screws.
With no area on the shaft to grip,
the shaft often turns when attempt-
ing to remove the second screw.
To ease removal of second screw,
a 5mm hex socket has been
provided at the bottom of the
threads in both ends of the shaft.
Insert a 4mm hex key wrench into
this socket after removing one
screw to hold the shaft for
removal of the second screw.
See Figure 4-2.
3M-Matic Accuglide 3 - 3 Inch Taping Head
™
Page 13
44-0009-2071-8 / ECO# 0078045
(continued)
dirt from taping heads by
blowing it out with
compressed air.
This can cause the dirt to
be blown inside components
onto sliding surfaces. Dirt in
these areas can cause serious
equipment damage.
Never wash down or subject
taping heads to conditions
causing moisture condens-
ation on components.
Serious equipment damage
could result.
Source Document for all related Manuals/Translations
Warning
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- Turn air and electrical supplies off
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box drive
system is running
Warning
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fingers away from
tape cutoff blades under orange blade
guards. The blades are extremely sharp.
5mm Hex
Key Wrench
Figure 4-2 Roller Shaft Section View
Original Instructions
Hex Socket
Section View of
Roller/Shaft
International - ENG
February 2021