Box Drive Belt Tensioning - 3M Matic 8000a-I Instructions And Parts List

13. Maintenance and Repairs
Discharge End
Figure 13-4 Box Drive Belt Tension Adjustment
13.10 Drive Belt Tension
3M-Matic 8000a-I / 8000a3-I - Type 11700
™
Page 34
44-0009-2161-7 / ECO# 0078483
(continued)
Box Drive Belt
Tension adjustment of the drive
belts may be required during normal
operation. Belt tension must be
adequate to positively move the box
through the machine and they should
run fully on the surface of the pulleys
at each end of the frame.
The idler pulleys on the infeed end
are adjusted in or out to provide
proper belt tension. Each belt is
adjusted separately. Belt tension is
obtained by tightening the adjustment
screw so that a moderate pulling force
of 3.5 kg [7 lbs] applied at the mid
span, as shown in Figure 13-4, will
deflect the belt 25mm [1 inch]. This
will assure positive contact between
the belt and the drive pulley on the
discharge end of the taping head.
To adjust belts, see "Maintenance –
Drive Belts", steps 3 and 7.
3.5kg (7lbs) Pull Force
with 25mm (1 inch) at Mid span
Infeed End
Warning
• To reduce the risk associated with
mechanical and electrical hazards:
- Read, understand, and follow all safety
and operating instructions before
operating or servicing the case sealer.
- Allow only properly trained and
qualified personnel to operate and
service this equipment.
Warning
• To reduce the risk associated with
pinches, entanglement and hazardous
voltage:
- Turn electrical supply off and disconnect
before performing any adjustments,
maintenance or servicing the
machine or taping heads.
International - ENG
February 2021