Arc Control Settings; Stick Scratch Start - Miller EnPak A30 GBW Owner's Manual

11-4. Arc Control Settings

.
Arc Control is not active when the Process switch is in the GTAW Lift-Arc TIG position.
.
Miller recommends Hobart filler metals.
Process/Contactor Switch

11-5. Stick Scratch Start

.
A complete Parts List is available at www.MillerWelds.com
Arc Control
SOFT
(−25 to −1)
L (0)
STIFF
(1 to 25)
Voltage sensing feeder
SOFT
(−25 to −1)
L (0)
STIFF
(1 to 25)
1
3
Starting point for stainless steel wire (high inductance)
SOFT -12
Starting point for mild steel wire
Starting point for aluminum wire (low inductance)
STIF 12
Flat or horizontal welds with XX18 electrode with short weld cables
Starting point
Stiffer, more rapidly responding arc for XX10 electrode
With Stick selected, start arc as
follows:
1 Electrode
2 Workpiece
3 Arc
Drag electrode across workpiece like
striking a match; lift electrode slightly
after touching work. If arc goes out
electrode was lifted too high. If
electrode sticks to workpiece, use a
2
quick twist to free it.
.
Miller recommends Hobart filler
metals.
OM-283757 Page 53