Frequency Converter Feedback To Network; Bibbs - Danfoss DriveMotor FCP 106 BACnet Operating Instructions Manual

BACnet Objects
5.1.3 Multi-state Value Objects
ID Default name
MSV:0 Smart Logic Controller State 1638
MSV:1 Active Setup
Table 5.8 Multi-state Value
5.2 Frequency Converter Feedback to
Network
5 5
The BACnet option provides several output variables
(nvo's) objects to the network, containing important
frequency converter-, motor- and I/O feedback data. The
BACnet option transmits bound network variables only and
sends feedback data when there is a change in value.
Influence of the digital input terminals upon the FC
Control Mode, 8-50 Coasting Select to 8-56 Preset Reference
Select
The influence of the digital input terminals upon control of
the frequency converter can be programmed in
8-50 Coasting Select to 8-56 Preset Reference Select.
NOTICE
8-01 Control Site overrules the settings in 8-50 Coasting
Select to 8-56 Preset Reference Select and Terminal 37,
Safe Stop overrules any parameter.
Each of the digital input signals can be programmed to
logic AND, logic OR, or to have no relation to the
corresponding bit in the control word. In this way a
specific control command i.e. stop/coast, can be initiated
by the fieldbus only, fieldbus AND Digital Input, or
Fieldbus OR Digital input terminal.
NOTICE
To control the frequency converter via BACnet, set
8-50 Coasting Select to either [1] Bus or to [2] Logic AND
and set 8-01 Control Site to[0] Digital and ctrl. word or [2]
Control word only.
18
VLT
Object_Name
Parameter
CTW
MG03O102 - Danfoss A/S © 12/2013. All rights reserved.
®
DriveMotor FCP 106 & FCM 106 BACnet Operating Instructions
Present_Value
Bit number Writeable
n/a
13 x

5.3 BIBBs

ReadProperty
WriteProperty
DeviceCommunicationControl
ReinitializeDevice
I-Am
I-Have
TimeSynchronization
Who-Has
Who-Is
Table 5.9 BIBBs
Cmd.able Timeout
x x
Execute
Execute
Execute
Execute
Initiate
Initiate
Execute
Execute
Execute