Danfoss DriveMotor FCP 106 BACnet Operating Instructions Manual page 26

Parameters
8-81 Bus Error Count
Range:
0 [0 - 65536 ] This parameter shows the number of telegrams
*
8-82 Slave Messages Rcvd
Range:
0 [0 - 65536 ] This parameter shows the number of valid
*
8-83 Slave Error Count
Range:
6 6
0 [0 - 65536 ] This parameter shows the number of error
*
8-84 Slave Messages Sent
Range:
0 [0 - 65536 ] This parameter shows the number of messages
*
8-85 Slave Timeout Errors
Range:
0 [0 - 65536 ] This parameter shows the number of follower
*
8-88 Reset FC port Diagnostics
Option:
[0] Do not reset
*
[1] Reset counter
6.2.6 8-9* Bus Feedback
8-94 Bus Feedback 1
Range:
0 [-32768 -
*
32767 ]
24
VLT
Function:
with faults (e.g. CRC fault), detected on the
bus.
Function:
telegrams addressed to the follower, sent by
the frequency converter.
Function:
telegrams, which could not be executed by the
frequency converter.
Function:
sent from the follower.
Function:
timeout errors.
Function:
Function:
Write a feedback to this parameter via the
serial communication port. This parameter
must be selected in 20-00 Feedback 1 Source
as a feedback source. (Hex-value 4000 h
corresponds to 100% feedback/range is
±200%)
MG03O102 - Danfoss A/S © 12/2013. All rights reserved.
®
DriveMotor FCP 106 & FCM 106 BACnet Operating Instructions