Summary of Contents for Rinnai Flametech LS Series
Page 1
MODELS Flametech® (RHFE0800F) Flametech® (RHFE1000F) LS1000 (RHFE1000) LS1500 (RHFE1500) LS Series - Gas Fireplace Operation Manual...
Page 2
Congratulations on the purchase of your Rinnai LS Series Gas Fireplace. We trust you will have many years of comfort and enjoyment from your appliance. BEFORE USING THIS APPLIANCE Before proceeding with the operation or installation read this manual thoroughly and gain a full IMPORTANT understanding of the appliance, to ensure safe and correct use.
For safety and warranty purposes, appliances that may be damaged or incorrect must not be installed or operated under any circumstances. Installation of damaged or incorrect appliances may contravene local government regulations. Rinnai disclaims any liability or responsibility whatsoever in relation to the installation or operation of damaged or incorrect appliances.
WARNING: This heater MUST NOT be used if any of the glass panels are damaged. Flue terminal MUST always vent directly to outdoors. DO NOT extend the flue vertically or horizontally in ways other than prescribed in this appliance manufacturer’s installation instructions. ONLY the flue components specified by Rinnai must be used. When considering...
When the heater is operated for the first time or after long periods of non use a slight odour may be emitted, this is normal. However if odours persist switch ‘OFF’ the appliance and contact Rinnai. Young children should be supervised at all times. Hand or body contact with the warm air discharge louvres and glass must be avoided.
These devices within the appliance automatically cut of the gas supply to the burners in the event of a flame failure. Refer to the “CARE AND MAINTENANCE” pages; 13 through 15 for further information. Pressure Relief The burner box glass panel is secured to the burner box via spring loaded pressure relief fasteners. Rinnai RHFE0800F_1000_1500 OM...
Room temperature display: Displays the current temperature of the room in which the control is located. See "Remote Control Operation" on page 10. Room temperature sensor Senses the temperature of the room in which the control is located. Rinnai RHFE0800F_1000_1500 OM...
In the event that either method of remote operation is not available, this appliance may still be operated in a limited capacity by using the power Standby / ON button as described in the note above. Rinnai RHFE0800F_1000_1500 OM...
NOTE Refer to "Control Panel Operation" on page 9 for details on how to use the appliance in this mode and the limitations of this form of operation. Rinnai RHFE0800F_1000_1500 OM...
Noting that 0X (OK) will briefly be shown on the digital display to confirm that the batteries have been successfully replaced. Remember to dispose of used button batteries immediately and safely. IMPORTANT Rinnai RHFE0800F_1000_1500 OM...
Screen Tips & Guides - The app supports a extensive inbuilt app user guide and screen tips function. For more information about how to use the Rinnai Wi-Fi App, refer to the ‘Wi-Fi control user guide’ available on the Rinnai website, www.rinnai.com.au, enter "Wi-Fi user guide" into the search field.
Wi-Fi module has gone offline. The appliance is fitted with an overheat safety switch which will shut off the appliance. If the appliance shuts off repeatedly servicing or inspection of the flue for may be required, contact Rinnai for advice. NORMAL OPERATIONAL CHARACTERISTICS During the initial burning in period some fumes and smell may be experienced.
If the power supply cord or any other component of the heater are damaged, they MUST BE replaced by Rinnai or a suitably qualified person. Rinnai has a Service and Spare Parts network with personnel who are fully trained and equipped to give the best service on your Rinnai appliance.
/ inadequate flue system or the artificial logs/burn media may have shifted from when the heater was first installed. There are some warning signs that could indicate a problem. If any of the signs below occur, please contact Rinnai. NORMAL FLAME PATTERN...
Filters should be removed regularly for cleaning with a soft brush, cloth or vacuum. The following diagram shows the location of the filter access. Filter is located on lower edge adjacent to the glass Grip hold of edge of Filter and pull straight up Rinnai RHFE0800F_1000_1500 OM...
Is the appliance positioned in a suitable location (clearances, combustible clearances, mantels and surrounds etc.)? 2. Was a Rinnai approved flue system installed and tested in accordance with the instructions? 3. Has the gas pressure been checked and set? 4. Has the log set / burn media been installed as per instructions? 5.
Model Number * Serial Number * Installation Address: * This information will need to be copied from the data plate, located on the inside of the appliance. Ensure this Operation Manual is left with the customer. IMPORTANT Rinnai RHFE0800F_1000_1500 OM...
Tel: 1300 555 545* Monday to Friday, 8.00 am to 5.00 pm EST. *Cost of a local call may be higher from mobile phones. For further information visit www.rinnai.com.au or email enquiry@rinnai.com.au innai has a Service and Spare Parts network with...
Need help?
Do you have a question about the Flametech LS Series and is the answer not in the manual?
Questions and answers