Power Off The Device - Cisco Firepower 1010 Getting Started Manual

Power Off the Device

---------- --------------- ----------------- ----------- -----------
Power Off the Device
It's important that you shut down your system properly. Simply unplugging the power can cause serious file
system damage. Remember that there are many processes running in the background all the time, and unplugging
or shutting off the power does not allow the graceful shutdown of your Firepower system.
The Firepower 1010 chassis does not have an external power switch.You can power off the device using
FDM, or you can use the FXOS CLI.
Power Off the Device Using FDM
You can shut down your system properly using FDM.
Procedure
Step 1
(6.5 and later) Use FDM to shut down the device.
Note
a) Click Device, then click the System Settings > Reboot/Shutdown link.
b) Click Shut Down.
Step 2 Observe the Power LED and Status LED to verify that the chassis is powered off (appear unlit).
Step 3
After the chassis has successfully powered off, you can then unplug the power to physically remove power
from the chassis if necessary.
Power Off the Device at the CLI
You can use the FXOS CLI to safely shut down the system and power off the device. You access the CLI by
connecting to the console port; see
Procedure
Step 1 In the FXOS CLI, connect to local-mgmt:
firepower # connect local-mgmt
Step 2
Issue the shutdown command:
firepower(local-mgmt) # shutdown
Example:
Cisco Firepower 1010 Getting Started Guide
84
1 FPR-1010 Cisco Systems, In JMX1943408S 0.3
For 6.4 and earlier, enter the shutdown command at the FDM CLI.
Access the FTD and FXOS CLI, on page
Firepower Threat Defense Deployment with FDM
81.