Operation; Turn On/Off; Zeroing; Weighing With Tare - KERN RFC Series Operating Manual

9 Operation

9.1 Turn on/off

To turn on/off operate the on/off switch at the
underneath side on the right of the scale and keep
pressed for a little while. The balance will carry out
a self-test As soon as the weight display shows "0"
in all the three display windows your balance is
ready to weigh.
To switch-off push shortly to the right the switch-
on/switch-out on the right lower side of the balance.

9.2 Zeroing

Resetting to zero corrects the influence of light soiling on the weighing plate.
 Unload the balance
 Press
, the balance starts resetting to zero.
The indicator [] above

9.3 Weighing with tare

 Deposit weighing vessel. When stability display appears, press
display and the indicator [] above [NET] appear.
 Weigh the material, the net weight will be indicated.
 The weight of the weighing container will be displayed as a minus number after
removing the weighing container.
 To delete the tare value unload the weighing plate and press
[] above [GROSS] appears.

9.4 Overload warning

Overloading exceeding the stated maximum load (max) of the balance, minus a
possibly existing tare load, must be strictly avoided. This could cause damage to
the balance.
Exceeding maximum load is indicated by the display of "„-OL-", and an audio
sound. Unload balance or reduce preload.
26
appears.
. Zero
, the indicator
RFC-BA-e-2113