Drive Specification - Moons' M2DV-1D82D User Manual

M Series AC Servo
User Manual

2.2.3 Drive specification

200W
Input
400W
Power
750W
Withstand voltage
Temperature
Environment
Humidity
Altitude
Vibration
Control method
Encoder feedback
Control Signal
Analog signal
I/O
Pulse signal
USB Mini
RS232
Communication
RS485
CAN bus
Ethernet
Front panel
Regeneration Resistor
Control mode
Control input
Control output
Rev. 1.1
9/13/2021
Main Circuit
Single/3-phase, 200 - 240V ±10%, 50/60Hz
Control Circuit
Single phase, 200 - 240V ±10%, 50/60Hz
Main Circuit Single/3-phase, 200 - 240V ±10%, 50/60Hz
Control Circuit Single phase, 200 - 240V ±10%, 50/60Hz
Main Circuit Single/3-phase, 200 - 240V ±10%, 50/60Hz
Control Circuit Single phase, 200 - 240V ±10%, 50/60Hz
Primary to earth: withstand 1500 VAC, 1 min, (sensed current: 20 mA) [220V Input]
Ambient temperature:0°C to 50°C(If the ambient temperature of servo drive is greater than 45°C,
please install the drive in a well-ventilated location)
Storage temperature: -20°C to 65°C
Both operating and storage : 10 to 93%RH or less
Lower than 1000m
1g
IGBT PWM Sinusoidal wave drive
2500 line incremental encoder 15-wire or 9-wire
8 Configurable Optically isolate digital general inputs, 5-24VDC, max input current 20mA
Input
4 Configurable Optically isolate digital high speed inputs, 5-24VDC, max input current 20mA
5 Configurable optically isolated digital outputs, 30VDC, max output current 30mA
Output
One motor brake control output, 30VDC 100mA max
Input
2 inputs (12Bit A/D:2 input)
2 inputs (Photo-coupler input, Line receiver input)
Input Photocoupler input is compatible with both line driver I/F and open collector I/F.
Line receiver input is compatible with line driver I/F.
Output 4 outputs ( Line driver: 3 outputs, open collector: 1 outputs)
Connection with PC or 1:1 communication to a host.
RS-232 Communication
RS-485 Communication
CANopen Communication
EtherNET/IP, eSCL
1. 4 keys (MODE, UP, DOWN, SET) 2. LED (5-digit)
Built-in regenerative resistor (external resistor is also enabled.)
(1) Position mode
(2) Analog Velocity mode
(3) Analog Position mode
(4) Position mode
(5) Velocity Change mode
(6) Command Torque mode
(7) Command Velocity mode
(1) Servo-ON input
(2) Alarm clear input
(3) CW/CCW Limit
(4) Pulse& Direction or CW/CCW input
(5) Gain Switch
(6) Control mode Switch
(7) Pulse Inhibition
(8) General Input
(1) Alarm output
(2) Servo-Ready output
(3) External brake release
(4) Speed arrival output
(5) Torque arrival output
(6) Tach Out
(7) General Output
(8)Position arrival output
12
400-820-9661