Installation And Connections; Basic Connections; Operation - Sanyo DSR-5709P Instruction Manual

3

INSTALLATION AND CONNECTIONS

This section describes how to connect the digital video recorder to video cameras and other devices. Be sure to read the instruction
manuals for each connected device.
Improper connections may result in malfunction or smoke emission.
A separate power supply is required for operation of each camera.
Manage power for all expansion units with a single power source. Otherwise, data may be lost.

Basic connections

DSR-5716P
Only nine cameras can be connected to the DSR-5709P.
The following diagram shows the connections for cameras, monitors, a PC and a system controller.
Cameras
(sold separately)
1 - 16
1 2 3
IN
OUT
USB
ALL
RESET
PC
(commercially-available)
English
VGA monitor
(sold separately)
MENU
4 5 6 7 8 9
LAN IN OUT VGA OUT
AUDIO
Video input
terminal
01 02
03 04
Monitor
(sold separately)
AUTO MODE POWER
10 11 12 13 14 15 16
MAIN MON2
RS-485 RS-485
TERMINATE A SANYO SSP B
OFF ON
MONITOR OUT
DO NOT CONNECT TO PHONE LINE
The RS-485 connector is
connected to A or B according
to the type of cable.
Video input
terminal
Monitor 2
(sold separately)
13
AC IN
ALARM IN
C 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
2ND
RS-485/422 REMOTE
SENSOR
ALARM OUT
A B C R1 R2 OUT C
EXCEPT SANYO SSP
SELECTABLE
OUTPUT 1 :
NON REC OUT/VIDEO LOSS
OUTPUT 2 :
ARACHIVE FULL/TIMER REC OUT
CONTROL
120 V – 240 V AC
(50/60 Hz)
System controller
(sold separately)