Connections - Sanyo SRT-7168P Instruction Manual

CONNECTIONS

Connect the video camera and monitor TV as shown in the figure below.
NOTE:
Before making the connections, make sure the devices are disconnected from the power outlet.
AC IN ~
Power
cord
To outlet
IMPORTANT NOTE (U. K. Only)
The wires in the mains lead are coloured according
to the following code:
Blue:
Brown:
If the colours of the wires in the mains lead of this
apparatus do not correspond with the colour
markings identifying the terminals in your plug,
proceed as follows:
œ The wire which is coloured blue must be
connected to the terminal which is marked with
the letter N or coloured blue or black.
œ The wire which is coloured brown must be
connected to the terminal which is marked with
the letter L or coloured brown or red.
œ Do not connect either wire to the Earth terminal.
Video camera
(sold separately)
From an external
audio source
Neutral
Live
Monitor TV (sold separately)
To
VIDEO IN
jack
EXT WARNING TAPE SW ALARM
TIMER IN COM OUT END OUT OUT COM OUT IN
RS485
A B
CLOCK SET SERIES OUT/ SERIES TIMER DC 10-30V IN
OUT IN NON REC OUT IN COM OUT – +
ADDRESS TERMINATE
485
ON ON
OFF OFF
232
AUDIO VIDEO
IN OUT IN OUT
REMOTE MIC IN
RS232C
To
VIDEO
OUT
jack
Coaxial cable
To remote control
(sold separately)
(sold separately)
NOTES:
œ For more details, please refer to the manuals
accompanying all other devices. If the connections
are not made properly, it may cause a fire or damage
the equipment.
œ You can use a VA-RMN01 Remote Control Unit (sold
separately) to control remotely the VCR.
œ If there is no video signal when the power is turned
on, "NO VIDEO" will be displayed on-screen.
œ Use a DC power cord rated A.W.G 18 (1.25 mm
more.
œ The table below indicates the DC power source
output and DC power maximum cord lengths.
DC power source output
18 V or more 2 A
12 ~ 16 V
10 V
10 V
6
PUSH
OPEN
DC power
maximum cord
lengths
6 m
3 A 6 m
5 A 6 m
4 A 2 m
2
) or
English