Installation And Connections; Basic Connections; Connecting An Amplifier; Connecting Alarm In Terminals - Sanyo DSR-3506 Instruction Manual

3

INSTALLATION AND CONNECTIONS

This section describes how to connect the digital video recorder to video cameras and other devices. Be sure to read the
instruction manuals for each connected device.
Improper connections can result in malfunction or the
emission of smoke.
A separate power supply is required for operation of
each camera.

Basic connections

The following diagram shows the connections for cameras, monitors, a microphone, and a PC.
Camera
(sold separately)
1 2 3
Microphone
MIC IN
IN OUT
AUDIO
* Wrap the microphone
cable twice around the
supplied core clamp
before attaching it.
01
03
Monitor
(sold separately)

Connecting an amplifier

An amplifier is connected when using a microphone or
external speakers with the digital video recorder.
Audio input
Audio
output
IN OUT
4 5 6
IN
VIDEO
OUT
MAIN MON2
MONITOR
*
Video input Video input
terminal terminal
02
04
Monitor
(sold separately)
Amp
(sold separately)
ALARM IN
SENSOR
ALARM OUT
LAN
* If the monitor 2 (MON2) is not synchronized
with the connected cameras, vertical picture
instability may occur upon the switching of
camera video.

Connecting ALARM IN terminals

When using external alarms (i.e., intruder sensors and the
like), external switches are to be connected to the ALARM
IN terminals.
C 1 2 3
10
ALARM
FULL
ALARM
RESET
C 1 2 3 4 5 6 C AC IN
ALARM OUT
C 1 2 3 4 5 6 C C
REMOTE
C R1 R2 C
ALL
RESET
120V-240V AC
(50/60 Hz)
PC
Connecting ALARM IN
terminals to external
switches
4 5 6 C
English