Sanyo DSR-5709P Instruction Manual page 74

1 INITIAL SET
The above examples are set as follows.
<TIME PERIOD SET> screen
TIME PERIOD A
T-1=6:00, T-2=13:00, T-3=20:00, T-4=00:00
TIME PERIOD B
T-1=6:00, T-2=11:00, T-3=13:00, T-4=00:00
SEQUENCE
"TIME PERIOD A"
MASK
"TIME PERIOD B"
<MAIN/MON.2 MONITOR SET> screen
T-1
All "OFF"
T-2
"OFF" except cameras No. 1, 5, 9 and 12
T-3
"OFF" except cameras No. 1, 8 and 16
<MASK SET> screen
T-1
"ON" for cameras No. 2, 4, 5, 7, 10 and 16.
T-2
"ON" for cameras No. 1, 4, 6, 11, 12, 13 and 14.
T-3
All "OFF"
English
Operations during the specified time periods
The following menu settings must be made to enable
operation of the time periods. After completing these settings,
be sure to then carry out the timer setting.
Setting automatic selection of camera video
Select the camera to be automatically selected to display
video and set the switching interval.
To do this, set "SEQUENCE SET" from the <SCREEN SET>
screen. ( P.134)
Masking camera video using a gray pattern
Use "MASK" from the <SCREEN SET> screen to specify
which cameras are to be displayed on the monitor and which
are not. ( P.136)
Alarm recording using motion sensors
Set "MOTION SENSOR" from the <ALARM REC MODE
SET> screen. ( P.105)
73
<SCREEN SET>
1.MULTI SCREEN : NORMAL
QUAD POSITION SET ->
MULTI 9 POSITION SET ->
MULTI 16 POSITION SET ->
2.SEQUENCE SET
FULL : 1S QUAD : 1S
MAIN/MON.2 MONITOR SET ->
3.MASK : OFF
MASK SET ->
4.COLOR LEVEL SET ->
<SCREEN SET>
1.MULTI SCREEN : NORMAL
QUAD POSITION SET ->
MULTI 9 POSITION SET ->
MULTI 16 POSITION SET ->
2.SEQUENCE SET
FULL : 1S QUAD : 1S
MAIN/MON.2 MONITOR SET ->
3.MASK : OFF
MASK SET ->
4.COLOR LEVEL SET ->
<ALARM REC MODE SET>
ALARM RECORDING : OFF
PICTURE QUALITY : ENHANCED
PICTURE QUALITY SET ->
AUDIO RECORDING : OFF
ALARM INTERLEAVE : ONLY
REC RATE: 15FPS, DURATION: 20SEC
PRE-ALARM RECORDING : ***
REC RATE: ***** FPS, DURATION: *****
ALARM TRIGGER : ALARM
MOTION SENSOR ->