Sanyo DSR-5709P Instruction Manual page 209

9 ADVANCED MENU SET
6
Set up "SMTP SERVER ADDRESS" and
"PORT".
For "PORT", specify a port number (0 to 65535) for use in
SMTP (transmission). (Default setting: 25)
7
Set "USER MAIL ADDRESS" to the e-
mail address from which notifications
are sent.
8
Specify "ON" or "OFF" for "USE" under
"SEND MAIL ADDRESS".
[Settings] ( indicates default setting)
Setting
OFF Alarm notification is disabled.
ON Alarm notification is enabled.
9
Enter the recipient's e-mail address
under "MAIL ADDRESS".
10
Set "IMAGE" to "ON" or "OFF".
[Settings] ( indicates default setting)
Setting
OFF An alarm image is not attached to the e-mail.
ON An alarm image is attached to the e-mail.
11
Specify "ON" or "OFF" for each item
under "WARNING".
You can configure the main unit to send warning notification
mail messages when the following problems are detected in
the functionality and operation of the main unit.
You can configure the warning notification feature the same
way as the alarm notification feature. All settings default to
"OFF"; turning "ON" an item causes the main unit to send
warning mail when the corresponding condition is detected.
HDD:
Either when abnormal condition occurred in the hard disk
drive or temperature has risen to 70 degrees or more there.
V. LOSS:
The video signal is disconnected.
FAN:
The fan is faulty.
NON REC:
The DVR has stopped recording.
FULL:
Any one of the recording areas on the hard disk has
reached the "remaining-space" warning level or has
become full.
POWER:
The power has turned off and back on again.
Description
Description
If you use the "WARNING" function, specify "ON" for
"ALARM NOTICE" in Step 4.
Since "USE" in Step 8 applies to alarm notification, it does
not affect the setting for "WARNING". A warning
notification mail message is sent normally when "ON" is set
for it.
12
Use the same procedure to set the e-
mail addresses of other e-mail
recipients.
Up to eight recipient e-mail addresses can be set.
13
Set "SUBJECT" to the subject of the
notification e-mail.
14
Set "AUTHENTICATION" to select
whether authentication is to be
performed.
[Settings] ( indicates default setting)
Setting
NO USE User authentication is not performed.
POP3 (POP before SMTP) authentication is
POP3
performed.
SMTP SMTP authentication is performed.
15
If "POP3" is selected for
"AUTHENTICATION", you need to
specify "POP3 SERVER ADDRESS" and
"PORT".
For "PORT", specify a port number (0 to 65535) for use in
POP 3 (reception). (Default setting: 110)
16
If "POP3" or "SMTP" is selected for
"AUTHENTICATION", you need to
specify "USER ID" and "PASSWORD".
17
Click [SAVE].
The setting is saved.
The digital video recorder supports the following SMTP
authentication:
• CRAM-MD5 • LOGIN
For the digital video recorder to perform authentication, the
provider must have authentication settings made. Make the
authentication settings after confirming the type of
authentication supported by the connected provider.
208
Description
English