KYMCO BET & WIN 50 Manual page 9

1
. GENERAL INFORMATION
 After clamping, check each wire to make
sure it is secure.
 Do not squeeze wires against the weld or
its clamp.
 After clamping, check each harness to
make sure that it is not interfering with
any moving or sliding parts.
 When fixing the wire harnesses, do not
make it contact the parts which will
generate high heat.
 Route wire harnesses to avoid sharp
edges or corners. Avoid the projected
ends of bolts and screws.
 Route wire harnesses passing through the
side of bolts and screws. Avoid the
1-7
www.PlanDeGraissage.org
projected ends of bolts and screws.
BET & WIN 50
No Contact !