Measuring The Ring-Gear-To-Stopper-Bolt Clearance; Adjusting The Ring-Gear-To-Stopper-Bolt Clearance - Yamaha FJR 1300 AE 2014 Service Manual

Ring gear shims
Thickness (mm)
0.25 0.30 0.40 0.50
Thrust washers
Thickness (mm)
1.2 1.4 1.6 1.8 2.0
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS23600
MEASURING THE RING-GEAR-TO-
STOPPER-BOLT CLEARANCE
1. Remove:
• Ring gear bearing housing
(along with the ring gear)
Refer to "ADJUSTING THE FINAL GEAR
BACKLASH" on page 4-114.
2. Measure:
• Ring-gear-to-stopper-bolt clearance "a"
Out of specification → Adjust.
Ring-gear-to-stopper-bolt clear-
ance
0.30–0.60 mm (0.0118–0.0236 in)
1. Stopper bolt
2. Ring gear
3. Install:
• Ring gear bearing housing
(along with the ring gear)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS23610
ADJUSTING THE RING-GEAR-TO-
STOPPER-BOLT CLEARANCE
1. Remove:
• Ring gear "1"
• Stopper bolt "2"
• Stopper bolt shim(s) "3"
• Ring gear bearing housing "4"
▲▲▲
2. Select:
• Stopper bolt shim(s)
Stopper bolt shims
3. Install:
• Ring gear bearing housing "1"
• Stopper bolt shim(s) "2"
• Stopper bolt "3"
• Ring gear "4"
ECA14320
NOTICE
• The stopper bolt has left-hand threads. To
tighten the stopper bolt, turn it counter-
clockwise.
• Apply LOCTITE® onto the stopper bolt.
4. Measure:
• Ring-gear-to-stopper-bolt clearance
4-115
SHAFT DRIVE
Thickness (mm)
0.15 0.20
Stopper bolt
9 Nm (0.9 m·kg, 6.5 ft·lb)