Yamaha FJR 1300 AE 2014 Service Manual page 497

Fault code No.
Item
1 Condition of intake air pres-
sure sensor hose.
Check the intake air pressure
sensor hose condition.
2 Defective intake air pressure
sensor.
TIP
If fault code numbers "13" and "14" are both indicated, take the actions specified for fault code number
"13" first.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Meter display
01
Procedure
14
Intake air pressure sensor: hose system malfunction (clogged
or detached hose).
Clogged or detached hose
→ Repair or replace the sen-
sor hose.
Execute the diagnostic
mode. (Code No. 03)
When engine is stopped:
Atmospheric pressure at the
current altitude and weather
conditions is indicated.
At sea level: Approx. 101 kPa
(757.6 mmHg, 29.8 inHg)
1000 m (3300 ft) above sea
level: Approx. 90 kPa (675.1
mmHg, 26.6 inHg)
2000 m (6700 ft) above sea
level: Approx. 80 kPa (600.0
mmHg, 23.6 inHg)
3000 m (9800 ft) above sea
level: Approx. 70 kPa (525.0
mmHg, 20.7 inHg)
When engine is cranking:
Make sure that the indication
value changes.
The value does not change
when engine is cranking. →
Check the intake air pressure
sensor.
Replace if defective.
Refer to "CHECKING THE
INTAKE AIR PRESSURE
SENSOR" on page 8-211.
15
Throttle position sensor: open or short circuit detected.
Able/Unable to start engine
Able/Unable to drive vehicle
01, 13
Throttle position sensor signal 1
• 12–21 (fully closed position)
• 97–106 (fully open position)
• Check with throttle valves fully closed.
• Check with throttle valves fully open.
8-46
FUEL INJECTION SYSTEM
Start the engine and let it idle
for approximately 5 seconds.
Fault code number is not dis-
played → Service is finished.
Fault code number is dis-
played → Go to item 2.