Yamaha FJR 1300 AE 2014 Service Manual page 443

1. Check:
• Accelerator position sensor
Refer to "CHECKING THE ACCELERATOR
POSITION SENSOR" on page 8-210.
2. Adjust:
• Accelerator position sensor angle
TIP
Before adjusting the accelerator position sensor,
the throttle bodies must be removed.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Temporary tighten the accelerator position
sensor bolts.
b. Check that the throttle valves are fully closed.
c. Turn the main switch to "OFF".
d. Connect the accelerator position sensor to
the wire harness.
e. Connect the throttle cables to the throttle bod-
ies.
f. Simultaneously press and hold the "TCS"
button "1" and "RESET" button "2", turn the
main switch to "ON", and continue to press
the buttons for 8 seconds more.
1
2
3. Multi-function meter right display
TIP
All displays on the multi-function meter right dis-
play disappear and "DIAG" appears.
g. Simultaneously press the "TCS" button "1"
and "RESET" button "2" for 2 seconds or
more to set the diagnostic mode.
1
2
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
DIAG
3
DIAG
DIAG
01
DATA
15
TIP
The diagnostic code number "01" appears on
the multi-function meter right display.
h. Diagnostic code number "14" is selected.
i. Turn the throttle grip to the fully closed posi-
tion.
j. Adjust the position of the accelerator position
sensor angle so that 12–22 can appear in the
meter display.
▼▼▼ k. After adjusting the accelerator position sen-
sor angle, tighten the accelerator position
sensor bolts "3".
l. Turn the throttle grip to the fully open position.
m. Check the meter display value. If the meter
display value is not 97–107, adjust the accel-
erator position sensor angle.
n. Select the diagnostic code number "15".
o. Turn the throttle grip to the fully closed posi-
tion.
p. Check the meter display value. If the meter
display value is not 10–24, adjust the acceler-
ator position sensor angle.
q. Turn the throttle grip to the fully open position.
r. Check the meter display value. If the meter
display value is not 95–109, adjust the accel-
erator position sensor angle.
s. Repeat steps (h) to (r) until the meter display
values are within the specified ranges.
t. If the meter display values are not within the
specified ranges after repeating steps (h) to
(r) several times, replace the accelerator po-
sition sensor.
▲ ▲▲▲ ▲ ▲▲▲ ▲
7-12
THROTTLE BODIES
Accelerator position sensor bolt
3.5 Nm (0.35 m·kg, 2.5 ft·lb)
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
3
3
▲ ▲▲▲ ▲ ▲▲▲