Yamaha FJR 1300 AE 2014 Service Manual page 19

Automatic deactivation
condition
Unable to maintain the set
cruising speed
Traction control system is
engaged
Wheel slip or wheel spin is
detected
Start/engine stop switch is
set to the " " position
Engine stalls
Sidestand is extended
Because the automatic deactivation of the cruise control system is stored in the memory of the ECU,
the deactivation can be checked using the Yamaha diagnostic tool.
TIP
In some cases, the cruise control system may not be able to maintain the set cruising speed when the
vehicle is traveling uphill or downhill.
• When the vehicle is traveling uphill, the actual traveling speed may become lower than the set cruising
speed. If this occurs, accelerate to the desired traveling speed using the throttle.
• When the vehicle is traveling downhill, the actual traveling speed may become higher than the set
cruising speed. If this occurs, the setting switch cannot be used to adjust the set cruising speed. To
reduce the traveling speed, apply the brakes. When the brakes are applied, the cruise control system
will become deactivated.
• If the cruise control system turns off automatically while the cruising speed is not set, the cruise control
setting indicator light "SET" will not flash.
Vehicle condition for
detection
Cruise control system
is turned on and cruis-
ing speed is set
Cruise control system
is turned on
1-10
Multi-function meter indication
Cruise control system indicator light "
goes off and cruise control setting indica-
tor light "SET" flashes for 4 seconds
FEATURES
"