Yamaha FJR 1300 AE 2014 Service Manual page 121

1. Starter motor lead
2. ECU (engine control unit)
3. Brake hose (front brake master cylinder to brake
pipe/lower joint assembly)
4. Right handlebar switch lead
5. Throttle cable (accelerator cable)
6. Throttle cable (decelerator cable)
7. Headlight relay (on/off)
8. Radiator fan motor relay
9. Starter relay coupler
10. Front right turn signal light coupler
11. ABS test coupler lead
12. Yamaha diagnostic tool connector
13. Right radiator fan motor coupler
14. Negative battery lead
15. O sensor lead
2
16. Water pump breather hose
17. Crankshaft position sensor lead
18. O sensor coupler
2
19. SCU (suspension control unit) fuse
20. Fuse box 2
21. Fuse box 1
22. Fuse box 3
23. Fuses (brake light and cruise control system)
24. ECU (engine control unit) leads
25. Wire harness
A. Blue tape
B. To electrical components board
C. Cover the positive battery lead terminal and starter
motor lead terminal with the covers.
D. Pass the starter motor lead through the guide on
the electrical components tray.
E. Insert the projection on the wire harness holder
completely into the hole in the electrical
components tray.
F. Fasten the right radiator fan motor lead with the
holder on the air guide.
G. Route the right radiator fan motor lead between the
leads (starter motor lead, negative battery lead,
and O sensor lead) and the base of the holder
2
that is fastening the leads.
H. Fasten the negative battery lead, starter motor
lead, O sensor lead, and water pump breather
2
hose with a plastic locking tie, making sure to
install the tie around the end of the hose's
protective sleeve, and then cut off the excess end
of the tie. Do not kink the water pump breather
hose and do not face the end of the plastic locking
tie downward.
I. The plastic locking tie on the O
should be positioned to the front of the bracket.
J. Install the fuse holder for the brake light fuse and
cruise control system fuse completely onto the tab
on the electrical components tray.
K. Install the fuse boxes securely onto the brackets
until a distinct "click" is heard.
L. Fasten the leads with the plastic band so that they
are positioned in a straight line as shown in the
illustration. Face the end of the plastic band
forward. Do not cut off the excess end of the plastic
band.
M. Outward
sensor lead
2
2-50
CABLE ROUTING
N. Route the O sensor lead to the outside of the
2
other leads and the hose.