Advertisement
Parts and their functions ([Live] screen)
Main area (IP video display area)
The IP video of the connected camera will be displayed.
Operating the mouse wheel inside the display area allows you to use the plug-in viewer software's digital zoom. [Windows]
When the shooting scenes vary significantly, restrictions imposed by the graphics processing (GDI) of the operating system
installed may give rise to a phenomenon called screen tearing (where parts of the picture are not displayed in synchronization)
although this will depend on the personal computer used.
On a personal computer running Windows, if [H.264 transmission] is set to [On], H.264 images and JPEG images can be dis-
played. When it is set to [Off], only JPEG images will appear.
Furthermore, on a personal computer running OS X (Mac), only JPEG images will be displayed regardless of the [H.264 trans-
mission] settings. (H.264 images will not appear.)
"H.264 transmission" (see page 104)
When [H.264 transmission] is set to [On], the frame rate for JPEG images may drop, regardless of whether H.264 images are
being transmitted.
The frame rate for JPEG images may be reduced depending on the network environment, performance of the personal computer
used, subjects and number of access users.
Up to 14 users (consisting of users receiving H.264 images and users receiving JPEG images) can access the unit at the same
time.
However, depending on the settings for the [Bandwidth control (bit rate)] and [Max bit rate (per client)], the number of users who
can access the unit may be limited to less than 14.
If the maximum number of users who can access the unit has exceeded the upper limit, a message advising that the unit is being
accessed by more users than the maximum number allowed is displayed. [Windows]
IP video is cannot be transmitted when [CCU MODE] is set to [2160/23.98p], [2160/23.98psf], [1080/23.98p], or
[1080/23.98psF].
[Compression] button
Switch between H.264 image display and JPEG image display.
1
When selected, the text "H.264" on the button turns green, and H.264 images are displayed. [Windows]
The [H.264] button is enabled when the [H.264 transmission] setting of [H.264 (1)] to [H.264 (4)] is set to [On] in the
[H.264]
IP video settings.
"H.264 (1)・H.264 (2)・H.264 (3)・H.264 (4)" (see page 103)
2
When selected, the text "JPEG" on the button turns green, and JPEG images are displayed.
[JPEG]
In the following cases, the selection status of the [Compression] buttons will return to the setting configured in the [Video over IP]
tab; [Initial display settings for "Live" page] - [Stream]. [Windows]
When returning from another screen
When the screen is updated
[Stream] button
These buttons appear only when H.264 images are displayed. [Windows]
Images are displayed according to the setting configured with [H.264 (1)] / [H.264 (2)] / [H.264 (3)] / [H.264(4)].
- 97 -
Web Screen
Advertisement
