Supermicro SuperServer SYS-511E-WR User Manual page 49

Installing a Drive
To install a drive into the chassis, first remove the drive carrier from the chassis.
1. Press the release tab to release the drive carrier from its locking position.
2. Pull the drive carrier out from the chassis as shown below:
Pull out the drive carrier from the
chassis
Press the release tab
3. Remove the dummy tray insert by first removing two screws, then pull out the dummy
tray as shown in the illustration below.
Remove the screws
Chapter 3: Maintenance and Component Installation
Drive carrier
Figure 3-6. Removing Front Drive
Take out the dummy tray insert
Drive carrier
Figure 3-7. Removing Dummy Tray
49
Dummy tray
insert