Installing The Rails; Identifying The Rails - Supermicro SuperServer SYS-511E-WR User Manual

2.4 Installing the Rails

There are a variety of rack units on the market, which may require a slightly different assembly
procedure. This rail set fits a rack between 25.6" and 33" deep.
The following is a basic guideline for installing the system into a rack with the rack mounting
hardware provided. You should also refer to the installation instructions that came with the
specific rack you are using.

Identifying the Rails

The chassis comes with two sets of rack rails, one set for the right side of the chassis and
one for the left. Each set consists of an inner rail that is pre-attached to the chassis, and an
outer rail that attaches to the rack.
Figure 2-1. Identifying the Sections of the Rack Rails
Warning: do not pick up the server by the front handles. They are designed to pull
the system from a rack only.
Chapter 2: Server Installation
Inner rail:
pre-attached to the chassis
Outer rail, front and rear brackets
24