Table of Contents
Advertisement
Tilting Table
Using the table tilt knob (see Figure 16), you can
adjust table tilt from 0°–45° left and 0°–15° right to
make beveled cuts. A tilt scale is embedded in the
table surface for quick angle adjustments, and a
table lock knob is provided to quickly secure the
desired angle.
Note: Table tilt scale serves as a guide only. For
more accurate results, use a bevel gauge or pro-
tractor to set desired table tilt relative to blade.
Table Tilt Scale
Table Lock
Knob
Table Tilt
Knob
Figure 16. Table tilt controls.
Tilting Table
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen table lock knob (see Figure 16).
3.
Use table tilt knob to tilt table to desired
angle, then tighten table lock knob.
Note: When tilting table for cutting operation,
adjust shoe so it remains parallel with table.
Refer to Adjusting Hold-Down Shoe on
Page 21.
Using Positive Stop (Left Tilt)
Tool Needed
Open-End Wrench 10mm .................................. 1
The positive stop (see Figure 17) allows you to
quickly return the table to 0° from a left-tilt set-
ting. The positive stop is adjustable, allowing for
calibration, or if desired, minor deviations from 0°.
-22-
To use positive stop (left tilt):
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen table lock knob (see Figure 16).
3.
Use table tilt knob to tilt table to desired
angle, then secure position by tightening
table lock knob (see Figure 16).
4.
Loosen jam nut on stop bolt (see Figure 17),
and turn bolt until it just touches top of posi-
tive stop rest.
Positive
Stop
Rest
Figure 17. Location of positive stop components.
5.
Tighten jam nut to secure stop bolt setting.
Note: Check table tilt scale and make sure
positive stop bolt is correctly calibrated (see
Checking/Calibrating Positive Stop on
Page 23).
Using Positive Stop (Right Tilt)
Tool Needed
Open-End Wrench 10mm .................................. 1
For right-hand tilt operations, the positive stop
(see Figure 17) can be adjusted from 0°–15° by
making incremental changes to the stop bolt posi-
tion or by rotating the stop rest out of the table tilt
path.
Qty
Jam Nut
Positive
Stop Bolt
Positive
Stop
Model G0938 (Mfd. Since 03/21)
Bolt
Qty
Advertisement
Table of Contents
