Table of Contents
Advertisement
6.
Place locking pliers on table tilt adjust-
ment cable directly behind cable lock
(see Figure 36).
Note: Locking pliers will prevent cable run-
out and keep tensioning spring located in
table scale from losing tension.
7.
Loosen lock screw holding cable lock in place
(see Figure 36).
8.
Loosen cable adjustment nut (see Figure 36).
Cable Lock
Table Tilt
Adjustment
Cable
Figure 36. Scale adjustment components.
9.
Lightly pull adjustment cable out until table tilt
scale reads 0°.
10. Tighten lock screw on cable lock to hold
cable securely.
11. Tighten cable adjustment nut.
12. Align blade (refer to Aligning Blade Holders).
13. Install insert, hold down shoe, and machine
housing panel.
Model G0938 (Mfd. Since 03/21)
Cable Adjustment Nut
Lock Screw
Aligning Blade
Holders
The blade holders may become misaligned with
use, which results in the blade no longer being
aligned with the motion of the arm and being out
of square with the table. The most common symp-
tom of this condition is persistent blade run-out.
Tools Needed
Hex Wrench 5mm .............................................. 1
Machinist's Square ............................................ 1
To align blade holders:
1.
Perform all steps in Calibrating Table Tilt on
Page 32.
2.
DISCONNECT MACHINE FROM POWER!
3.
Ensure table tilt is set at 0°.
4.
Remove hold-down shoe.
5.
Place machinist's square flat on table with one
edge against side of blade (see Figure 37).
Blade
Table
Figure 37. Squaring blade to table.
— If blade is square to table no further adjust-
ments need to be made.
— If blade is not square to table proceed to
Step 6.
Qty
Square
-33-
Advertisement
Table of Contents
