Tilting Frame - Grizzly G0969 Owner's Manual

Tilting Frame

The Model G0969 features a tilting frame, which
allows the workpiece to always be in a parallel
position. The tilt controls for the frame are located
at the front of the saw, beneath the table.
For convenience, there are preset stops at 0°, 45°,
30°, and 22.5°, left and right.
Note: Left tilt is limited to 37 degrees with dust
port installed. To achieve full 45° tilt, dust port
must be removed.
Note: Tilt scale serves as reference only. For
more accurate results, use a bevel gauge or pro-
tractor to set desired frame tilt relative to blade.
Tilting Frame
1.
DISCONNECT MACHINE FROM POWER!
2. Loosen frame lock lever (see Figure 15).
Tilt Scale
Figure 15. Frame tilt controls.
3.
Use frame tilt knob to position table to desired
angle.
4.
Tighten frame lock lever to secure frame
position.
Model G0969 (Mfd. Since 07/23)
Using Preset Stops
The preset positive stops allow the frame to quick-
ly be set to any of seven frequently used angles.
To use preset stops:
1.
2.
3.
Frame Lock
Lever
4.
Frame
5.
Tilt
Knob
DISCONNECT MACHINE FROM POWER!
Loosen frame lock lever (see Figure 16).
Preset Stop Indexing
(1 of 7) Pin
Figure 16. Location of preset stop controls.
Use frame tilt knob to position arm to desired
preset angle.
Push spring loaded indexing pin into preset
stop.
Note: Press pin gently while turning knob.
You will feel pin drop into stop.
Tighten frame lock lever.
Frame
Lock Lever
Frame Tilt
Knob
-21-