Squaring Blade To Table - Grizzly G9743 Owner's Manual

Squaring Blade to
Table
Over the life of the saw, this adjustment should be
performed to improve cutting results and extend
blade life.
Tools Needed
Square ............................................................... 1
Hex Wrench 6mm .............................................. 1
To square blade to table:
1. DISCONNECT MACHINE FROM POWER!
2. Lower headstock completely.
3. Place square on table bed and against edge
of blade (see Figure 74), and check different
points along length of table between blade
guides.
Square
Figure 74. Example of square placed on table
bed against edge of blade.
— If blade is square to table, no adjustment
is necessary.
— If blade is not square to table, proceed to
Step 4.
-50-
Qty
Blade
4. Lightly pull cutting fluid hose bibs to remove
cutting fluid hoses from blade guide assem-
blies (see Figure 75).
Figure 75. Location of cutting fluid hose bib
(lower blade guide assembly shown).
5. Loosen cap screw on blade guide assembly
that needs adjustment (see Figure 75), and
rotate blade guide until blade is vertical to
bed.
Note: Both blade guides can be adjusted to
bring blade into square.
Figure 76. Location of adjustment cap screw
(upper blade guide assembly shown).
6.
Tighten cap screw(s).
7.
Press hose bibs into blade guide assemblies
to install cutting fluid hoses.
Model G9743 (Mfd. Since 10/23)
Cutting Fluid
Hose Bib