Table of Contents
Advertisement
TOOLS REQUIRED
FOR ASSEMBLY
(1)
(2)
(2)
(2)
(2)
(2)
(1)
Standard Screwdriver
15/16" Wrenches (one should be box-end)
3/4" Wrenches
9/16" Wrenches
1/2" Wrenches
7/16" Wrenches
3/8" Wrench
ADDITIONAL
iTEMS
NEEDED
Ruler or Tape Measure
Grease
REMOVE
PARTS FROM CARTON
•
Remove the hardware pack and all loose parts from
the carton.
Lay cardboard on floor to help prevent scratching of
painted parts.
Lay out and identify all the parts and hardware as
shown on pages 4 through 6.
5/16" WASHERS (DD)
5/16"
NYLOCK NUT
_/8"x 1-1/4"
j
HEX BOLT (D)
/'-v
/./
3/8" NYLOOK NUT (R)
318" HEX NUT (Q)
FIGURE 1
ASSEMBLE
SCOOP
STEP 1: iNSTALL TWO BOLTS
(SEE FIGURE 1)
Assemble two 3/8" x 1-1/4" hex bolts (D) and 3/8" hex
nuts (Q), threading the nut all the way onto the bolt
until it is tight against the head of the bolt.
Install a nut/bolt assembly into the bucket assembly
and fasten using a 3/8" nylock nut (R). Tighten.
Repeat for the other side.
STEP 2: iNSTALL PiN STOP BRACKET
(SEE FIGURE 1)
Install the pin stop bracket to the top of the bucket
assembly using four 5/16" x 1" hex bolts (F), eight
5/16" washers (DD) and four 5/16" nylock nuts (S).
Leave the bolts loose enough that the position of the
pin stop bracket can be adjusted later.
STEP 3: iNSTALL LiFT FRAME ASSEMBLY
(SEE FIGURE 2)
Apply grease to the mounting surface of the bucket
assembly and the inside of the lift frame arms.
Assemble the lift frame assembly to the bucket
assembly using two 5/8" x 1-1/2" hex bolts (A) and
5/8" nylock nuts (M). Tighten,
then loosen the nuts
1/4 turn, or until the lift frame pivots freely.
5/8" x 1-1/2"
HEX BOLT
(A)
\
APPLY
GREASE /
APPLY
LiFT FRAME
GREASE
ASSEMBLY
J
5/8" NYLOCK
NUTS (M)
J
J
APPLY GREASE
5/8" x 1-1/2"
HEX BOLT (A)
FIGURE 2
Advertisement
Table of Contents
