Table of Contents
Advertisement
STEP 14: iNSTALL DUMP HANDLETUBE
(SEE FIGURE 13)
•
Install the dump handle tube to the dump pivot bracket
assembly using three 5/16" x 1-3/4" hex bolts (G) and
5/16" nylock nuts (S).
DUMP PIVOT
BRACKET
\
5/16"
NYLOCK
NUT (S)
/
5/16"
x 1-3/4"
HEX BOLTS
(G)
FIGURE 13
STEP 15: INSTALL DUMP HANDLE TUBE EXTENSION
(SEE FIGURE 14)
Install the dump handle tube extension on the dump
handle tube using a 1/4" x 1-3/4" hex bolt (H) and 1/4"
nylock nut (T).
Attach the dump cable to the dump handle tube using
three cable ties (OO).
DUMP HANDLE
TUBE EXTENSION
1/4" x 1-3/4"
HEX BOLT (H)
\
\
USE THiS HOLE
\
\
CABLE
I/4"NYLOCK
NUT (T)
FIGURE 14
DUMP HANDLETUBE
11
STEP 16: iNSTALL DUMP CONTROL PiN
(SEE FIGURE 15)
Install a small 1/2" washer (FF) and then the
compression spring (MM) onto the dump control pin.
Install the dump control pin into the pin stop bracket.
Make sure the flat side of the pin faces to the front
when finished.
Connect the hooked end of the dump cable into the
hole in the dump control pin. Install the threaded cable
adjuster down into the notch in the pin stop bracket,
placing a nut on each side of the notch. Adjust and
tighten the adjuster nuts so that the tapered end of
the dump control pin extends 3/4" through the side of
the pin stop bracket.
DUMP CONTROL PIN
3/4"
_
-,,--
/
/
PiN STOP
BRACKET
DUMP CONTROL PiN
I
SMALL
1/2" WASHER
(FF)
./SPRING
(MM)
@%_/
HOOK
/
{
/
CABLE
/
ADJUSTER
PiN STOP
BRACKET
FIGURE
15
Advertisement
Table of Contents
