StarTech.com CABCONS1716I User Manual page 57

table with the following headings:
#:You can assign a value (1 ~ 99) to each attached serial remote
control module. This does not affect the configuration or operation of
the device in any way, but is simply a means to sort this list for ease of
management.
Name/Description: An identifier for the R-Port module. Like the
number assignment, it is for ease of administration only.
Baud (bps): This is the communication speed for the device, and the
setting here must match the setting on the module itself. All common
baud rates between 300 and 115,200bps are supported.
Mode: Sets the character framing scheme that the CABCONS1716I
will use with the R-Port module. You can choose from the following
selections:
8N1: Eight bits, no parity, one stop bit (default and most common)
7N1/701/7E1/7M1/7S1: Seven bits, (none/odd/even/mark/space)
parity, one stop bit
8N1/801/8E1/8M1/8S1: Eight bits, (none/odd/even/mark/space)
parity, one stop bit
8N2: Eight bits, no parity, two stop bits
Force DCD: Forces the Carrier Detect signal to be active at all
times. Normally, DCD becomes active when a new user connects
and is dropped when the last user disconnects (a response that is
similar to many modems). When active, the device will logout and
reset itself if the carrier signal is lost, increasing security. Note that
this may not work with all devices and could impair proper operation
in some circumstances. The default setting is off.
Console Log: Clicking this link will open a separate Web page that
will display the last 200 characters committed to that device's
console log. Note that existing data is overwritten automatically when
the 200 character limit is reached.
You can simultaneously make any required changes on this menu,
before applying your changes. Once complete, click Commit
changes to apply the new settings. Click Refresh at any time to see
an updated list of attached R-Port modules.
Instruction Manual
52