StarTech.com CABCONS1716I User Manual page 56

allows you to monitor and configure serial devices using the interactive
Web interface. To minimize space and infrastructure requirements, the R-
Port modules use a single cable to carry both power and the data signal.
All configuration settings are stored separately in each attached device in
non-volatile memory so that they will not be lost in the event of a power
outage or disconnection.
Connecting Serial Remote Control Modules to the CABCONS1716I
The cable for each serial device is similar to a phone cable and uses
an RJ-14 connector. For the first module, connect the cable (provided)
to the R-Port on the rear panel of the CABCONS1716I. Connect the
opposite end to the DATA OUT (or similar) port on the Serial Remote
Control unit. Note that some devices may use an integrated cable, so
you will not need to make a separate connection on the serial device.
Once you have added the first serial device to the CABCONS1716I,
you can connect additional modules to the DATA IN (or similar) port on
the previous module in the chain.
Once the cabling is attached, the module becomes active after a 15
second initialization period. For specific information regarding cabling
and status indicators for a specific serial console, refer to the
instructions that came with the product.
Configuring/Viewing Serial Remote Control Modules through the
Web Interface
Once you have one or more R-Port serial devices connected, you will
be able to configure and manage them through the Web interface. You
may need to modify the default settings on CABCONS1716I to match
your various R-Port modules' default configuration.
Consult the documentation that came with your R-Port module to
determine if you need to modify the default settings to complete the
installation. To be able to configure your RPort modules, you must be
logged in as admin. Other users will be able to view which modules
are active, but cannot configure them.
Once you are logged in, choose the Admin/Setup option from the
menu at the top of the Home screen in the Web interface. Click
External Serial consoles setup and control.
You will be presented with the Serial Consoles Attached menu, and a
Instruction Manual
51