Replacing Parts - Angelo Po FX 61 G2 Use And Installation Manual

INSTRUCTIONS AND WARNINGS FOR THE REPLACEMENT OF PARTS
Important
Before carrying out any replacement procedure, activate all the safety devices
provided and decide whether staff at work and those in the vicinity should be
informed. In particular, turn off the gas and water supply taps, cut off the elec-
tricity supply to the appliance using the master switch and prevent access to all
devices which might cause unexpected health and safety hazards if turned on.
If worn parts have to be replaced, use original spare parts only.
The manufacturer declines all responsibly for injury or damage to components
due to the use of non original parts, or extraordinary work on the appliance
which may modify the safety requirements without the manufacturer's authori-
sation.
When ordering components, follow the instructions provided in the parts cata-
logue.
Caution - warning
Replacement operations must be carried out by authorised, qualified staff, in
accordance with the relevant legal requirements.
REPLACEMENT OF THE BURNER NOZZLE
To carry out this operation, proceed as follows.
1 – Undo the screws to remove the side panel (A).
2 – Disconnect the gas supply line (B).
3 – Remove the injector (C) and replace it with the one suitable for the type of gas in
use (see table at back of manual).
Important
Take care to ensure that the nozzle (C) is correctly positioned (see diagram).
4 – Reconnect the pipe (B), replace the panel (A) and retighten the screws when the
operation is complete.
English

REPLACING PARTS

A
B
- 37 -
C
C
Use and installation manual
9
IT
GB
DE
FR
ES
IDM-39619301100.tif