Replacing Parts; Instructions And Warnings For Replacing Parts; Replacement Of The Burner Nozzle - Angelo Po AT 61G Use Manual

INSTRUCTIONS AND WARNINGS FOR REPLACING PARTS

Important
Before carrying out any replacement procedure, activate all the safety devices provided
and decide whether staff at work and those in the vicinity should be informed.
In particular, turn off the gas and water supply taps, cut off the electricity supply to the
appliance using the master switch and prevent access to all devices which might cause
unexpected health and safety hazards if turned on.
If worn parts have to be replaced, use original spare parts only.
The manufacturer declines all responsibly for injury or damage to components due to
the use of non original parts, or extraordinary work on the appliance which may modify
the safety requirements without the manufacturer's authorisation.When ordering
components, follow the instructions provided in the parts catalogue.
Caution - Warning
Replacement operations must be carried out by authorised, qualifi ed staff , in accordance
with the relevant legal requirements.

REPLACEMENT OF THE BURNER NOZZLE

To carry out this operation, proceed as follows.
1) Undo the screws to remove the side panel (A).
2) Disconnect the gas supply line (B).
3) Remove the injector (C) and replace it with the one suitable for the type of gas in use (see
table at back of manual).
Caution - Warning
GB
Take care to ensure that the nozzle (C) is correctly positioned (see diagram).
4) Reconnect the pipe (B), replace the panel (A) and retighten the screws when the operation is
complete.
3354462_ATG_inst_GB

REPLACING PARTS

A
B
- 16 -
C
C
ENGLISH