Multiload Ii+/Rcu Ii+ Firmware Preliminary Configuration - Toptech MultiLoad III Installation Manual
Division 2 (div2) hardware (loaded with multiload ii+ / rcu ii+ firmware)
Hide thumbs
Also See for MultiLoad III:
- Installation manual (68 pages) ,
- Installation instructions manual (16 pages)
Table of Contents
Advertisement
CHAPTER 6– CONFIGURATIONS
MultiLoad II+/RCU II+ Firmware Preliminary Configuration
Power-on the MultiLoad III/RCU III DIV2 Hardware.
1)
When the MultiLoad III DIV2 Hardware is first powered-on, running MultiLoad II+ Firmware, the
2)
card–in screen appears, indicating the Operating Mode.
When the RCU III DIV2 Hardware is first powered-on, running RCU II+ Firmware, the "System
Unavailable" message may appear if not connected to a host system
Go to program mode by entering 00000 on the keypad, then press Down.
3)
00000 is the factory default access code. See the "MultiLoad II/II+ Firmware User Guide," RCU
General Setup section for changing or adding new access codes.
39
For Access
Insert Driver Card
MultiLoad III/RCU III DIV2 Hardware Installation Guide - Part # 6074
Advertisement
Table of Contents
Need help?
Do you have a question about the MultiLoad III and is the answer not in the manual?
Questions and answers