TOHATSU BFT 150D Owner's Manual page 101

WATER
SEPARATOR
2 PIN COUPLER
(BLUE)
<Replacement>
1. Remove the engine cover (see page
41).
2. Disconnect the 2-pin coupler (blue).
FUEL HOSES
SUSPENSION
STRAP
3. Remove the suspension strap from
the fuel filter with water separator
bracket, then remove the
suspension strap from the fuel filter
with water separator.
4. Bind the two fuel tubes with the
tube clips to prevent the fuel
leakage, disconnect the fuel tubes.
HOSE CLIPS
MAINTENANCE
WATER SEPARATOR CUP
O-RING (Replace)
5. Remove the three screws holding the fuel
filter with water separator, delete the water
or deposit from the inside of the cup.
6. Thoroughly clean the cup, and
replace with a new fuel filter.
7. Reassemble the water separator in the
reverse order of removal. Use a new O-ring.
TIGHTENING TORQUE:
3.4 N·m (0.34 kgf·m, 2.5 lbs·ft)
SCREWS
99