Prepare Frame And Door - Assa Abloy NORTON RIXSON D6051 Series Installation Instructions Manual

D6011/D6051 Series Double Unit Pull Side Power Operator

Prepare Frame and Door

Become familiar with operator components and fasteners. It is recommended that components remain in boxes until
installed. Verify there is minimum ceiling clearance for operator installation before proceeding. (Figure 1)
A. Prepare frame.
1. Determine if push or pull installation. (Figure 2)
NOTE: These instructions are for Pair of Doors,
PULL only. See 80-9360-1030-020 instructions for
D6021/D6031 or 80-9360-1031-020 instructions for
D6061/D6071 Push installation.
2. Frame header MUST be flat / without twists.
Backplates can be used as reference.
NOTE: If frame is not flat or is twisted, additional
steel back plates or shimming is required. Failure
to mount units properly can result in improper
function of operator or inability to snap on
covers.
3. Mark center of opening on frame header
between jambs.
OR
4. Using chart, mark from center of opening to
left. (Figure 3)
NOTE: Template provided on page 28.
5. Measure 1" up from bottom of frame header and
mark at Dim A and Dim B locations.
6. Drill holes.
7. Using supplied backplate screw pack in Box 1,
insert screws into prepared mounting holes.
For Metal Frame: Use two (2) 1/4-20 x 1" flat head
machine screws.
For Wood Frame: Use two (2) #14 x 1-1/2" oval
head self-drilling screws.
NOTE: Do not tighten mounting screws at
this time. Leave 5/16" minimum (thickness of
backplate) between frame face and back of
screw head.
Copyright © 2019, 2020, 2023, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9360-1029-020 Rev 6 01/23
Approved 2023-01-24
Figure 1
Push Side
Pull Side
Right Hand
PULL
Figure 2
Door Size Dim A
Pair of 36" doors: 5-9/16" (141mm)
Pair of 38" doors: 7-9/16" (192mm)
Pair of 40" doors: 9-9/16" (243mm)
Pair of 42" doors: 11-9/16" (294mm)
Pair of 44" doors: 13-9/16" (344mm)
Pair of 46" doors: 15-9/16" (395mm)
Pair of 48" doors: 17-9/16" (446mm)
Figure 3
Left Hand
PULL
Center of Opening
Dim B
30-9/16" (776mm)
32-9/16" (827mm)
34-9/16" (878mm)
36-9/16" (929mm)
38-9/16" (979mm)
40-9/16" (1030mm)
42-9/16" (1081mm)
5