Prepare Frame And Doors - Assa Abloy Norton D6011 Series Installation Instructions Manual

D6011/D6051 Double Unit Series (Pull Side) Power Operator
Prepare Frame and Door
Become familiar with operator components and fasteners. It is recommended that components remain in boxes
until installed. Verify there is minimum ceiling clearance for operator installation before proceeding. (Figure 1)
A. Prepare frame.
1 . Determine if push or pull installation . (Figure 2)
NOTE: These instructions are for Pair of Doors,
PULL only. See 80-9360-1030-020 instructions
for D6021/D6031 or 80-9360-1031-020
instructions for D6061/D6071 Push installation.
2 . Frame header MUST be flat / without twists.
Backplates can be used as reference .
OR
NOTE: If frame is not flat or is twisted,
additional steel back plates or shimming is
required. Failure to mount units properly can
result in improper function of operator or
inability to snap on covers.
3 . Mark center of opening on frame header
between jambs .
4 . Using chart, mark from center of opening to left .
(Figure 3)
NOTE: Template provided on page 28.
5 . Measure 1" up from bottom of frame header and
mark at Dim A and Dim B locations .
6 . Drill holes .
7 . Using supplied backplate screw pack in Box 1,
insert screws into prepared mounting holes .
For Metal Frame: Use two (2) 1/4-20 x 1" flat
head machine screws .
For Wood Frame: Use two (2) #14 x 1-1/2" flat
head self-drilling screws .
NOTE: Do not tighten mounting screws at
this time. Leave 5/16" minimum (thickness of
backplate) between frame face and back of
screw head.
Copyright © 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9360-1029-020 Rev 5 11/20
Figure 1
Push Side
Pull Side
Right Hand
PULL
Figure 2
Door Size Dim A
Pair of 36" doors: 5-9/16" (141mm)
Pair of 38" doors: 7-9/16" (192mm)
Pair of 40" doors: 9-9/16" (243mm)
Pair of 42" doors: 11-9/16" (294mm)
Pair of 44" doors: 13-9/16" (344mm)
Pair of 46" doors: 15-9/16" (395mm)
Pair of 48" doors: 17-9/16" (446mm)
Figure 3
Left Hand
PULL
Center of Opening
Dim B
30-9/16" (776mm)
32-9/16" (827mm)
34-9/16" (878mm)
36-9/16" (929mm)
38-9/16" (979mm)
40-9/16" (1030mm)
42-9/16" (1081mm)
5