Prepare Frame And Doors - Assa Abloy Norton D6001DE-R Double Unit Series Installation Instructions Manual

D6001DE-R Double Unit Series (Double Egress) Power Operator

Prepare Frame and Doors

Become familiar with operator components and fasteners. It is recommended that components remain in boxes
until installed. Verify there is minimum ceiling clearance for operator installation before proceeding. (Figure 1)
A. Prepare frame.
Verify correct installation . (Figure 2)
NOTE: These instructions are for Pair of Doors,
where door on right is a Push door and door
on left is a Pull door. Arms included with this
assembly will fail if both doors are Pull doors
or if both doors are Push doors. Please contact
Customer Service or your local distributor if
this is the case.
OR
1 . Frame header MUST be flat / without twists.
Backplates can be used as reference .
NOTE: If frame is not flat or is twisted,
additional steel back plates or shimming is
required. Failure to mount units properly can
result in improper function of operator or
inability to snap on covers.
2 . Mark center of opening on frame header
between jambs .
3 . Mark from center of opening to left . (Figure 3)
NOTE: Template provided on page 29.
For pair of 36" doors:
For pair of 42" doors:
For pair of 48" doors:
4 . Measure 1" up from frame rabbet and mark at
Dim A and Dim B locations .
5 . Drill holes .
6 . Using supplied backplate screw pack in Box 1,
insert screws into prepared mounting holes .
For Metal Frame: Use two (2) 1/4-20 x 1" flat
head machine screws .
For Wood Frame: Use two (2) #14 x 1-1/2" flat
head self-drilling screws .
NOTE: Do not tighten mounting screws at
this time. Leave 5/16" minimum (thickness of
backplate) between frame face and back of
screw head.
Copyright © 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9360-1035-020 Rev 3 03/20
Dim A = 5-9/16"; Dim B = 30-9/16"
Dim A = 11-9/16"; Dim B = 36-9/16"
Dim A = 17-9/16"; Dim B = 42-9/16"
Figure 1
Push Side
Pull Side
Right Hand
PULL
Figure 2
Center of Opening
Figure 3
Left Hand
PULL
5