Advertisement
IMPORTANT! ADDITIONAL INFORMATION
Combination of tractor and mounted implement
The mounting of implements on the front or rear three point linkage shall not result
in exceeding the maximum permissible weight, the permissible axle loads and the
tyre load carrying capacities of the tractor. The front axle of the tractor must
always to be loaded with at least 20% of the unladen weight of the tractor.
Make sure before buying an implement that these conditions are fulfilled by
carrying out the following calculations or by weighing the tractor /
implement combination.
Determination of the total weight, the axle loads, the tyre load carrying capacity
and the necessary minimum ballasting
For the calculation you need the following data:
T
[kg] unladen weight of tractor
E
T
[kg] front axle load of unladen tractor
F
T
[kg] rear axle load of unladen tractor
R
I
[kg] combined weight of rear mounted
R
Implement / rear ballast
I
[kg] combined weight of front mounted
F
Implement / front ballast
1
see instruction handbook of the tractor
2
see price list and / or instruction handbook of the implement
3
to be measured
Consideration of rear mounted implement and front / rear combinations
1)
CALCULATION OF MINIMUM BALLASTING AT THE FRONT I
Record the calculated minimum ballasting which is needed at the front of the tractor into the table.
Front mounted implement
2)
CALCULATION OF THE MINIMUM BALLASTING AT THE REAR I
Record the calculated minimum ballasting which is needed at the rear of the tractor into the table.
All manuals and user guides at all-guides.com
1
a [m] distance from centre of gravity for
1
1
b [m] Tractor wheelbase
2
c [m] distance from rear axle centre to
2
d [m] distance from centre of lower link balls
Combined front mounted implement / front
ballast to front axle centre
centre of lower link balls
to centre of gravity for combined rear
Mounted implement / rear ballast
F min
R min
2 3
1 3
1 3
2
Advertisement
