ensto ECO16Touch User Manual page 48

Sensor Type
Mon 11:15
23.5
°
17:00
Manual Other...
Mon 11:15 Thermostat will use a
1
custom sensor type. Set
the 4 resistance values
23.5
°
for it ?
17:00
5
Manual Other...
Heating Schedule Heating Schedule
Adaptive Function
Heating Schedule Energy Use Energy Use Custom Sensor
6
Value 1
Open Window
User Settings Energy Use User Settings 8
15° 2303 Ω
2
Sensor Application
Engineer Settings User Settings Engineer Settings
7 7
Sensor Type Adaptive Function
Engineer Settings
Open Window Floor Sens. Calibr.
Adaptive Function Sensor Application Custom Sensor
Room Sens. Calibr.
Value 2
3
Temp. Scale Sensor Type
Open Window 8
20°
2303 Ω
Floor Sens. Calibr. Factory Reset Sensor Application
7 7
Room Sens. Calibr. Sensor Type
Factory
Temp. Scale Floor Sens. Calibr.
Factory Custom Sensor
Sensor - 10 kΩ Factory
Factory Reset Room Sens. Calibr.
Value 3
4
Sensor - 10 kΩ Sensor - 12 kΩ Sensor - 10 kΩ
8
Temp. Scale
25° 2303 Ω
Sensor - 12 kΩ Sensor - 12 kΩ
User Settings
Factory Reset
7 7
User Settings
User Settings
PAGE 48
This option allows you to choose the type of floor sensor used with the thermostat .
You can therefore choose to use an existing sensor with the thermostat, e .g . in
1
renovation projects .
Choose the sensor actually used from the list . The sensor supplied with the thermostat
is an sensor listed as: "Factory" .
• Sensor 10 kΩ
• Sensor 47 kΩ (default)
• Custom
1 . Tap the "Menu" button on the home screen .
2 . Then tap the "Engineer Settings" button .
Custom Sensor
Value 4
3 . Scroll down and tap the "Sensor Type" button .
8
30° 2303 Ω
4 . Tap the type of floor sensor actually used .
7 11
5 . Confirm your choice with "√" or discard it with "X" .
6 . If "Custom" is chosen, you must provide resistance values for the sensor
You have now set up
your custom sensor
concerned at four given temperatures: 15°C, 20°C, 25°C and 30°C – ask the
supplier of your sensor for these values .
7 . Use the "Right Arrow" or "Left Arrow" button to toggle through the temperatures .
8 . Tap the resistance value to change it .
9 . Tap the "Up Arrow" or "Down Arrow" button to set the resistance .
10 . Then repeat steps 6-9 until all four resistance values have been set .
11 . Tap the "Left Arrow" button to return to "Engineer Settings" .
< >
Contents