Table of Contents
Advertisement
■
[USB memory network settings]
Sets whether to permit the network setting using the
USB memory device. (see page 174)
[Permit]:
Permits USB memory network settings.
[Prohibit]:
Prohibits USB memory network settings.
Note
●
This function is set to [Permit] as factory default.
●
Once the network setting is done with USB memory
device, this function is set to [Prohibit].
■
[LAN control protocol]
Select the LAN control protocol.
[Protocol 1]:
Control with the Panasonic Display sequence.
[Protocol 2]:
Control with the sequence that is compatible with
Panasonic Projector.
Note
●
For PJLink and WEB browser control, the operation is
possible regardless of the setting.
●
When operating the "Multi Monitoring & Control
Software", select [Protocol 2].
■
[Reset]
You can reset the network setting to the factory default
of the Display.
Select [Yes] with
Network settings
Reset
Yes
Note
●
The settings for [NTP synchronization], NTP server
and [Time zone] will be reset to the factory default.
●
When [Security password] - [Security password] is
set to [On], it is necessary to input the password
when commanding [Reset].
86
English
and press <ENTER>.
No
USB media player settings
Set for "USB media player".
For details of the function, refer to "USB media player"
(see page 127).
Note
●
Depending on the setting for [Use memory select],
accessing devices differ. When [USB] is selected, a
USB memory device inserted to the USB terminal is
used. When [Internal memory] is selected, the internal
memory is used.
[USB media player settings] - submenu screen
USB media player settings
USB media player
Schedule play function
Video playback mode
Resume play
Still picture rotation
Playlist edit
Scenario file check
Codec information
Internal memory
No scenario file
Slide show duration
Schedule play function default setting
Play mode
Current setting
■
[USB media player]
Set to enable or disable the USB media player function.
■
[Schedule play function]
Enables/Disables the schedule playback function using
"Content Management Software".
Note
●
When [Schedule play function] is set to [Enable],
if both the scenario file of the existing "USB media
player" and the schedule file of this function are
present, the [Schedule play function] operation takes
priority.
●
[USB media player] cannot be changed during the
schedule playback mode.
●
When this function is set to [Enable], set [Quick start]
to [On] to enable the operation.
●
When [Quick start] is set to [Off], the unit enters the
standby state according to the schedule even if it is
set to [Enable]. However, the unit does not start up.
To operate the Schedule play function, it is necessary
to set [Quick start] to [On] and [Schedule play
function] to [Enable].
Enable
Enable
Standard
On
Landscape
10 sec
Individual play
Individual play
Advertisement
Table of Contents
