Table of Contents
Advertisement
Attaching the Function Board
When using a narrow-width function board, attach the
supplied SLOT adaptor, and insert it to the expansion
slot.
Note
●
Be sure to turn off the display unit and connected
devices, remove the power plug from the socket, and
disconnect the cables from the display.
●
When attaching/removing the function board, do not
allow the metal to damage the back cover or display
label.
When attaching a full-size function board, proceed to
step 4.
1
Remove one screw from the side with
the guide on the SLOT adaptor.
SLOT adapter
2
Fit the circuit board of the function
board in the guides of the SLOT
adaptor, and bring the circuit board
into contact with the hook (one
location) and the end faces (two
locations) securely.
Hook
End face
Guide
Screw
Function board
End face
3
Using the screw removed in step 1,
fix the function board to the SLOT
adaptor.
●
Tightening torque guideline: 0.5 N·m or less
Note
●
Firmly tighten the screw, and check that the hook of
the SLOT adaptor fixes the circuit board.
●
Check that the surface of the SLOT adaptor and the
surface of the circuit board match with each other
when the function board with the SLOT adaptor
attached is viewed from the opposite side of the
cover.
Make sure that this side is aligned.
Circuit board
×
It cannot be attached unless this side is horizontally
×
●
If there is a lead wire within approx. 3 mm from the
end face of the circuit board, the function board
cannot be attached due to interference with the guide
rail. Ensure that there is no lead wire in this range.
Circuit board
Screw
SLOT adaptor
aligned.
Approx. 3 mm
No lead wire in this range.
English
17
Advertisement
Table of Contents
