Selecting the input signal
Select the signals input to the unit.
Press <INPUT> or <INPUT (Unit)>.
Unit
INPUT
MENU
Switches input every time the buttons are pressed.
INPUT
MEMORY VIEWER
[HDMI1] → [HDMI2] → [HDMI3] → [USB-C] →
[SLOT] → [PC] → [Screen Transfer] →
[USB] or [Internal Memory] → [MEMORY VIEWER] →
[WHITEBOARD]
[HDMI1]: HDMI IN 1 terminal, HDMI input
[HDMI2]: HDMI IN 2 terminal, HDMI input
[HDMI3]: HDMI IN 3 terminal, HDMI input
[USB-C]: USB-C HOST terminal, USB-C input
[SLOT]: Input signal of the function board
[PC]*
:
PC IN terminal, PC input
1
[Screen Transfer]:
Input that displays images transmitted via network using
"Screen Transfer", a dedicated application by Panasonic
[USB]*
: USB terminal, USB input
2
[Internal Memory]*
: Image input from the internal
2
memory
[MEMORY VIEWER]: USB terminal, "Memory viewer"
input
[WHITEBOARD]: The screen switches "WHITEBOARD"
input.
*
: [PC] may be displayed as [PC [YP
1
on the settings of [PC input mode]. (see page 98)
*
: For [USB] and [Internal Memory] input, either one
2
selected for the [Use memory select] setting is
displayed. (see page 98)
-
+
ENTER
HDMI1
HDMI2
HDMI3
USB-C
SLOT
PC
PC[YP
P
]
B
R
Screen Transfer
USB
WHITEBOARD
P
]] depending
B
R
Note
●
Inputs set for [Input skip settings] or inputs when each
function is disabled cannot be selected. (see page 65)
●
Displays the signal name as set in [Input label]. (see
page 64)
●
Input will not be switched unless [Input lock] is set to
[Off]. (see page 71)
●
To switch between the component (color difference)
video and RGB for the PC IN terminal, make the
setting with [Setup] - [PC input mode]. (see page 98)
●
Image retention may occur on the LCD liquid crystal
panel when a still picture is kept on the panel for
an extended period. To prevent such a problem,
using the screensaver and the [Wobbling] function is
recommended. (see page 63, 64)
●
Switching to another input while the unit is connected
to Screen Transfer with Screen Transfer input will
break the connection. Check the connection again
after switching the input.
●
When [Whiteboard settings] - [Whiteboard] is set to
[On], the WHITEBOARD input is enabled. (see page
75)
39
English