Table of Contents
Advertisement
■
[Crestron Connected] page
Set the information required for connecting the control system of Crestron Electronics, Inc. to the Display, and the
information to monitor/control the Display using the control system of Crestron Electronics, Inc.
Click [Detailed set up] → [Crestron Connected].
[Control System]
Configure the setting for the control system required to connect to the Display as a client.
[Use TLS]
Sets the secure communication.
[Disable]:
Performs the unsecured communication.
[Enable]:
Performs the secure communication using TLS
(Transport Layer Security).
[IP Address / Hostname]
Enter the IP address or the host name of the
connection destination.
[IP ID]
Sets the IP ID used to determine the Display on the
network. (A number up to four digits)
Default value: 3
[Room ID]
Sets the Room ID used to determine the Display on
the network. (Up to 32 half-width characters)
[Non Secure Port]
Sets the port number to be used with the unsecured
communication.
Default value: 41794
Note
●
When [Use TLS] is set to [Disable], [Authentication] is fixed to [Disable], and [Secure Port] cannot be set.
[Secure Port]
Sets the port number to be used with the secure
communication.
Default value: 41796
[Authentication]
Select the authentication with the connection
destination used with the secure communication.
[Disable]:
Does not perform the connection authentication.
[Enable]:
Performs the connection authentication.
[User Name]
Enter the user name used for the connection
authentication. (Up to 20 half-width characters)
[Password]
Enter the password used for the connection
authentication. (Up to 20 half-width characters)
[Submit]
Updates the [Control System] setting.
123
English
Advertisement
Table of Contents
