Table of Contents
Advertisement
Basic Controls
98-inch model
Main Power On / Off button (
Main power switch (
86-inch model
75-inch model
55-inch model
50-inch model
Main Power On / Off button (
Main power switch (
(Back of the unit)
Remote control sensor / Power Indicator
36
English
) (Back of the unit)
) (Back of the unit)
AC cord (supplied)
AC socket outlet
Remote control sensor /
Power Indicator
65-inch model
43-inch model
) (Back of the unit)
)
AC cord
(supplied)
AC socket outlet
Operate pointing the remote control directly at the unit's
Remote Control Sensor.
Note
●
98-inch model only
For normal use, pull out the remote control sensor
from the edge side of the main unit by operating the
lever on the rear panel. (see page 33)
●
Do not put an obstacle between the remote control
sensor of the main unit and the remote control.
●
Operate the remote control in front of the remote
control sensor or from the area where the sensor can
be seen.
●
When directly aiming the remote control at the remote
control sensor of the main unit, the distance from
the front of remote control sensor should be approx.
7 m or less. Depending on the angle, the operation
distance may be shorter.
●
Do not subject the remote control sensor of the main
unit to the direct sunlight or strong fluorescent light.
1
Connect the AC cord plug to the
Display.
(see page 22)
2
Connect the plug to the socket outlet.
Note
●
Main plug types vary between countries. The
power plug shown at left may, therefore, not be
the type fitted to your set.
●
When disconnecting the AC cord, be absolutely
sure to disconnect the AC cord plug at the
socket outlet first.
●
The settings may not be saved if the power plug
is disconnected immediately after changing
settings with on-screen menu. Disconnect the
power plug after a enough period of time. Or,
disconnect the power plug after turning the
power off with the remote control, RS-232C
control or LAN control.
3
Turn ON ( ) the <Main power switch
(
)> on the unit.
Advertisement
Table of Contents
