Table of Contents
Advertisement
Precautions for use
Cautions when installing
Do not set up the Display outdoors.
The Display is designed for indoor use.
•
Install this unit at a location which can support the
weight of the unit.
Dropping or falling of the unit may cause injury.
•
Do not install the unit near a high-voltage line or a
power source.
Installing the unit near a high-voltage line or a power
•
source may receive interference.
Install the unit away from heat appliances.
Failure to do so may cause deformation of the cabinet
•
or malfunction.
Do not install the unit where it is 2 800 m (9 186 ft)
and higher above sea level.
Failure to do so may shorten the life of the internal
•
parts and result in malfunctions.
Environmental temperature to use this unit
When using the unit where it is below 1 400 m
•
(4 593 ft) above sea level: 0 °C to 40 °C (32 °F to
104 °F)
When using the unit at high altitudes (1 400 m
•
(4 593 ft) and higher and below 2 800 m (9 186 ft)
above sea level): 0 °C to 35 °C (32 °F to 95 °F)
We are not responsible for any product damage, etc.
caused by failures in the installation environment
even during the warranty period.
Transport only in upright position!
Transporting the unit with its liquid crystal panel
•
facing upright or downward may cause damage to the
internal circuitry.
Do not grab the liquid crystal panel.
Do not forcibly press the liquid crystal panel, or push
•
it with a pointed object. Applying a strong force to
the liquid crystal panel will cause unevenness of the
screen display, resulting in malfunction.
Do not install the product to a place where the
product is exposed to direct sunlight.
If the unit is exposed to direct sunlight even indoors,
•
the temperature rise of the liquid crystal panel may
cause malfunction.
In the case of storage, store the unit in a dry room.
Required space for ventilation
When installing the unit in a case or chassis, provide
•
a cooling fan or ventilation hole to ensure appropriate
ventilation so that the temperatures surrounding the
unit including the front surface of the liquid crystal
panel (temperature of inside the case or chassis)
can be maintained within the range of the operating
temperature of the unit.
About the screws used when using a wall hanging
bracket that conforms to VESA standards
Depth of screw hole
Screw for fixing the Display onto the wall-
hanging bracket (not supplied with the
Display)
●
Make sure that all screws are securely
tightened.
(View from the side)
Inch
Screw pitch for
model
installation
98
600 mm × 400 mm
86
600 mm × 400 mm
75
600 mm × 400 mm
65
400 mm × 400 mm
55
400 mm × 400 mm
50
400 mm × 400 mm
43
200 mm × 200 mm
Note for connection
Removing and inserting the power cord and
connection cables
When the unit has been installed on the wall, if the
•
power cord and connection cables are difficult to
remove and insert, make connections first before
installation. Be careful not to allow the cables to be
entangled. After installation is completed, insert the
power plug to the outlet.
Depth of
Screw
screw hole
(quantity)
18 mm
M8 (4)
20 mm
M8 (4)
20 mm
M8 (4)
20 mm
M8 (4)
18 mm
M6 (4)
20 mm
M6 (4)
16 mm
M6 (4)
English
11
Advertisement
Table of Contents
