Table of Contents
Advertisement
■
[USB memory network settings]
Sets whether to permit the network setting using the
USB memory device. (see page 151)
[Permit]:
Permits USB memory network settings.
[Prohibit]:
Prohibits USB memory network settings.
Note
●
This function is set to [Permit] as factory default.
●
Once the network setting is done with USB memory
device, this function is set to [Prohibit].
■
[LAN control protocol]
Select the LAN control protocol.
[Protocol 1]:
Control with the Panasonic Display sequence.
[Protocol 2]:
Control with the sequence that is compatible with
Panasonic Projector.
Note
●
For PJLink and WEB browser control, the operation is
possible regardless of the setting.
●
When operating the "Multi Monitoring & Control
Software", select [Protocol 2].
■
[Reset]
You can reset the network setting to the factory default
of the Display.
Select [Yes] with
Network settings
Reset
Yes
Note
●
The settings for [NTP synchronization], NTP server
and [Time zone] will be reset to the factory default.
●
When [Security password] - [Security password] is set
to [On], it is necessary to input the password when
commanding [Reset].
100
English
and press <ENTER>.
No
USB media player settings
Set for "USB media player".
For details of the function, refer to "USB media player"
(see page 128).
[USB media player settings] - submenu screen
USB media player settings
USB media player
Schedule play function
Video playback mode
Resume play
Still picture rotation
Playlist edit
Scenario file check
Codec information
No scenario file
Slide show duration
Schedule play function default setting
Play mode
Current setting
■
[USB media player]
Set to enable or disable the USB media player function.
■
[Schedule play function]
Enables/Disables the schedule playback function using
"Content Management Software".
Note
●
When [Schedule play function] is set to [Enable],
if both the scenario file of the existing "USB media
player" and the schedule file of this function are
present, the [Schedule play function] operation takes
priority.
●
[USB media player] cannot be changed during the
schedule playback mode.
■
[Video playback mode]
Sets the video playback mode.
If image disturbance occurs at the switching timing of
motion picture files during playback in [Standard] mode,
switch to [Adjust] mode.
[Standard]: Plays without a black image at the joint
between video files.
[Adjust]: Plays with a black image (approx.
2 seconds) inserted at the joint between
video files.
Note
●
When using the Multi Media Player, a black screen is
displayed for a certain period of time at the switching
timing of motion picture files regardless of the [Video
playback mode] settings.
●
The display may be disturbed at the switching timing
of files during playback in [Standard] mode.
●
When the schedule playback is proceeding using
"Content Management Software", [Video playback
mode] can be switched both in single mode and multi
mode.
Enable
Enable
Standard
On
Landscape
10 sec
Individual play
Individual play
Advertisement
Table of Contents
