Toshiba HWT-601XWHM3W-ETR Service Manual page 201

Exchange
No.
parts name
Compressor 1) Perform work of item 1 of
2) Extract refrigerant gas.
3) Remove the partition plate.
4) Remove the sound-insulation material.
5) Remove terminal cover of the compressor,
Never reuse the compressor lead which you
disconnected. Use the new one. If you reuse
it, it may malfunction.
6) Remove pipe connected to the compressor
7) Remove the fixing screw of the bottom plate
8) Remove the fixing screw of the bottom plate
9) Pull upward the refrigeration cycle.
10) Remove NUT (3 pcs.) fixing the
Reactor 1) Perform work of item 1 of
2) Remove screws fixing the reactors.
Work procedure
and , , , .
(Φ4 × 10, 4screws)
and disconnect lead wire of the compressor
from the terminal.
NOTE
with a burner.
• Take care to keep the 4-way valve away
from naked flames. (Otherwise, it may
malfunction.)
and heat exchanger. (Φ4 × 10, 1screw)
and valve fixing plate.
(Φ4 × 10, 2screws)
compressor to the bottom plate.
(Φ4 × 10, 2screws)
Partition
board
Compressor
Valve
fixing plate
, and .
Partition plate
200
Remarks
Reactor