Belt Clip Installation / Removal - Standard Horizon HX890E Owner's Manual

6.1.5 Installation of the SBT-13 Battery Case
The SBT-13 is a battery case that holds five "AAA" size Alkaline batteries and is
used with the HX890 transceiver. The Alkaline batteries can be used for reception
and transmission in an emergency, and battery life will be shortened dramatically.
1. Turn the transceiver OFF.
2. S lide the five "AAA" size Alkaline
batteries into the SBT-13 with the
Negative (−) side of the batteries
touching the spring connectors
inside the SBT-13.
Put three batteries into the
compartment on the front side
and two on the back side.
3. Slide the battery cover latch to
the "UNLOCK" position, then
press "PUSH" to open the battery
cover.
4. Install the SBT-13 into the battery
compartment and align it to the
battery contacts until it clicks.
5. Attach the battery cover, then
slide the battery cover latch to
the "LOCK" position.
To remove the battery case, turn the transceiver OFF, open the battery cover,
then push and lift up the bottom end of the battery case.
• When the SBT-13 Alkaline Battery Case is used, the HX890 transmit
output is fixed to 1 W.
• The HX890 will float with the SBT-13 attached.
6.2

BELT CLIP INSTALLATION / REMOVAL

1. To install, align the Belt Clip CLIP-22 to the groove of
the Battery pack, then press the Belt Clip downward
until it locks in place with a "Click".
2. To remove, pull the CLIP-22 tab away from the
battery pack to unlock the CLIP-22, then slide it
upward to remove it.
Front
NOTE
Back
UNLOCK
15